Node-RED, SCADA, Raspberry Pi, G RANCANG BANGUN POWER QUALITY DATA LOGGER MENGGUNAKAN SINGLE TRANDUCER

Authors

  • Muhamad Ryan Al-Fitra Mahasiswa

Abstract

In the electrical system there is a reading of measuring instruments, where in this measuring instrument, data is not stored. Therefore the data logger is made to make it easier to monitor an electrical system. To overcome this, a Raspberry Pi-based Data Logger system was designed. The application used is NodeRED which functions to send data to phpMyAdmin and it is this phpMyAdmin that will store the measurement data. For the results of data storage, the value of the voltage measurement is obtained at Gae EMG 25 176 V and at phpMyAdmin 175.7 V, from here it is obtained an error percentage of 0.17% obtained from dividing the values of phpMyAdmin and Gae EMG 25. The percentage of this error occurs due to the difference in time recorded on phpMyAdmin with the existing data measurement on Gae EMG 25.

Downloads

Published

2021-03-12

Issue

Vol. 9 No. 2 (2020): JAE

Section

Artikel

License

Copyright info for authors

1. Authors hold the copyright in any process, procedure, or article described in the work and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

2. Authors retain publishing rights to re-use all or portion of the work in different work but can not granting third-party requests for reprinting and republishing the work.

3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) as it can lead to productive exchanges, as well as earlier and greater citation of published work.