Analisis Multi Varian Pemesinan Bor Magnesium AZ31B Menggunakan Metode Taguchi Gray Relational Analysis
DOI:
https://doi.org/10.35143/elementer.v10i1.6237Abstract
This research aims to obtain optimal drilling machining parameters in response to tool life, surface roughness and response to the influence of electric current. Tool life is a derivative of the wear value obtained. The Taguchi method is often used to determine optimal quality in single response manufacturing processes. However, when there is more than one response, researchers often use the Gray Relational Analysis (GRA) method. This research was carried out on the response of tool life, surface roughness and the effect of electric current on Magneisum AZ31B type material using four factors and mix levels. The chisel diameters used are 8 mm and 10 mm. The spindle speed is set at 890 rpm, 1270 rpm, 1700 rpm and 2000 rpm, feeding uses values of 0.1 mm and 0.3 mm, while the point angles used are 118° and 135°. The optimal results obtained in this research were using a tool diameter of 8 mm, spindle speed of 890 rpm, feeding of 0.1 mm, and point angle of 118°. Keywords: Drilling, Taguchi Method, Gray Relational Analysis, Tool Wear, Surface Roughness, Electric Current.Downloads
Published
Issue
Section
License
Copyright (c) 2024 Panji Mario Leksono Leksono, Yanuar Burhanuddin, Gusri Akhyar Ibrahim, Suryadiwansa Harun
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Authors who publish with this journal agree to the following terms:
a. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
This work is licensed under a Creative Commons Attribution 4.0 International License.
